Skip to product information
1 of 6

Pacific CLD 360 Radiator

Pacific CLD 360 Radiator

SKU:CL-W282-CU00BL-A

Regular price $129.99 USD
Regular price Sale price $129.99 USD
Sale Sold out

High-performance radiator. Engineered with high-density copper, double-fin layout and quality materials.
View full details
  • Design
  • Specification
  • Download
  • How-to Videos

Pacific CLD 360 Radiator

The Pacific CLD Series Radiator is a copper radiator built with an highly efficient double-fin design and a brass tank. The radiator is compatible with 120mm high-static pressure fans with 40mm thickness for optimal heat dissipation, the CLD series is manufactured with a “reflow soldering manufacturing process” which provides exceptional cooling performance.

1 inch = 25 Copper and Brass Fins
(1inch = 2.54cm)

 
High-Quality Copper & Double Fin Radiator Design
 
Optimized Heat Dissipation & Dual-Row Copper Tubes with a Brass Tank
Based on our reflow soldering manufacturing process, the Pacific CLD Series is engineered with a thick 40mm radiator along with dual-row 12-set flat tube design and a brass tank. The radiator is optimized for efficiently which allows even heat dissipation from your internal components.
Image Displayed: Pacific CLD 240
Pacific CLD Series Radiator Models
240mm: 285.4 x 119 x 40
360mm: 406 x 119 x 40
480mm: 526.6 x 119 x 40
 
 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.