MSRP: $89.99   
P/N: CL-W001-PL00BL-A
Pump + Reservoir > Pacific PT40
Design Gallery Specification Support
 

Feature

Pacific PT40 Reservoir/Pump Combo
Thermaltake introduces the Pacific PT Series pump with tube reservoir set for the ultimate in custom PC watercooling configurations. Featuring exceptional performance and unrivalled reliability, the PT40 is manufactured from high quality POM and PMMA material to provide a crystal clear, high performance, and durable solution. By giving users ideal mounting, fitting and flow, the Pacific PT Series is the right choice for PC enthusiasts. Choose from: 200ml or 400ml and make your system a showcase for all to see with the Thermaltake Pacific PT Series.
 
Tt LCS Certified is a Thermaltake exclusive certification applied only to products that pass the design and hardcore enthusiasts standards that a true LCS chassis should hold to. The Tt LCS certification was created so that we at Thermaltake can indicate to all power users which chassis have been tested to be best compatible with extreme liquid cooling configurations, ensuring you get the best performance from the best features and fitment.
 





*PT20 water flow diagram
Driven Performance
Maximum discharge up to 500L/hr for efficient cooling of your components. Top cap supports rubber washers for a proper seal, including two predrilled G1/4” ports for fittings.
 
Heat-resistant Acrylic Tank
The Pacific PT Series tube reservoirs are all made of reliable, light weighted POM and PMMA construction, which is crystal clear and highly durable. High quality acrylic (PMMA) tube maximum working temperature: 131℉(55℃).





 
Remarkable Expansion
A bracket at each endholds the Pacific PT40 firmly inside the chassis and allows enthusiasts to not only build up an aesthetically superior liquid cooling system but also incorporate externally-modular upgrades for their chassis. The series provides multiple sizes for users to build the ultimate in custom configurations, and for a truly extraordinary chassis, the reservoir can be installed horizontally.



Cautions:
Thermaltake recommends the following steps to be taken after completing your water loop setup
  1. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  3. DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  4. Fill the reservoir to the top as it will prevent air from going into the pump
  5. If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  6. Place some paper towels under fittings and joining points to test for leaks.
  7. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop