Detail Information |
|
|
|
 |
 |
| There are two temperature shown
on the screen (T1, T2). T1 always mean pre-setting
temperature as well as T2 representatives the
temperature from sensor.
|
|
 |
ON / OFF:
power on or power off switch |
|
°C / °F: Celsius
and Fahrenheit display switch |
|
RESET:
clean the temperature setting. (MAX & MIN) |
|
REC: please
adjust the pre-setting temperature by using
the cross-head screw driver. When it shows the
temperature you would like to set, ( the screen
should be shown without MIN or MAX, see figure
1), please press the button to record the temperature |
|
Alarm Temp. Setting:
Control the temperature you would like to set |
|
Temp.
Display with alarm Specification:
 |
Range: 0 ºC ~ 90 ºC (32
ºF ~ 194 ºF) |
|
Resolution: 0.1 ºC (0.1
ºF) |
|
Accuracy: +/-1 ºC (+/-2
ºF) |
|
Sampling rate: 3 sec |
|
Alarm setting range: 40
ºC ~ 90 ºC |
|
Power: Lithium battery CR2032
3V |
|
|
 |
|
|
|
When the screen is shown MAX, it means
the highest temperature you have recorded. In the
meanwhile, T1 is the highest temperature you set,
T2 is the highest temperature that the sensor detected. |
|
On the other hand, MIN means the lowest
temperature that have been recorded. |
|
|
| Fan
speed controller operation |
|
|
|
|
If the fan unit you wish to
control is over 0.35Amp, please connect it
to either Speed Controller # 2 or 3. However,
the total current of fan unit is less than
0.35Amp, please connect it to Fan1 or Fan
4. |
|
If you wish to control a fan
unit with a 3pin power connection, please
use the included CPU Fan Adaptor. Once connected,
you may still monitor the RPM by connecting
the Yellow wire directly to motherboard. |
|
|
|
|
Example |
|
 |
An efficient way to
control the fan units is to chain connect each Silent
Fan Units. |
If 4 or more
Silent Fan Units are chain connected altogether, please
attach the set to either Speed Controller #2 or #3.
This is because each Silent Fan Unit requires 0.10Amp:
[0.1Amp X 4 Silent Fan Units] is greater than 0.35Amp,
so it must be connected to Fan2 or Fan3 only. |
 |
Then attach this set
to one of the Speed Controllers. |
|
|
Features
